Panasonic DMP-BDT460 Operating Instructions Manual

Also see for DMP-BDT360: Operating instructions Owner's manual Basic operating instructions

Panasonic DMP-BDT460 Operating Instructions Manual Manual pdf 30 page image

30 SQT0099∫ Quick StartSpeed of start-up from standby mode isincreased.≥ When set to “On”, the internal control unit will bepowered and the idle power consumption willincrease so compared to when set to “Off”.(Power consumption > 35)∫ Remote ControlChange the remote control code if otherPanasonic products react to this remote control.∫ Firmware Update (> 14)Press [OK] to show the following settings:¾Automatic Update CheckWhen this equipment remains connected to theInternet, it will check for the latest firmwareversion when it is turned on and you can updateit if necessary.¾Update NowYou can update the firmware manually if afirmware update is available.∫ System InformationPress [OK] to show the following settings:¾Software LicenceInformation about the software used by this unitis displayed.¾Firmware Version InformationDisplay firmware version of this unit andwireless LAN module.∫ Default SettingsReferenceTroubleshooting guideBefore requesting service, please perform thefollowing checks.If the problem remains unresolved, consultyour dealer for instructions.∫ Unit does not respond to remotecontrol or unit’s buttons.Disconnect the AC mains lead, wait 1 minute,then reconnect the AC mains lead.The following do not indicate a problem withthis unit:– Regular disc rotating sounds.– Image disturbance during search.∫ Cannot eject disc.1 Turn the unit on.2 Press and hold [OK], the yellow button andthe blue button on the remote control at thesame time for more than 5 seconds.4 Press [OK].To return to the factory defaults.¾ Select “Yes” in “Default Settings” in the Setupmenu. (> left)To return all settings to the factory preset.¾ Reset the unit as follows:1 Turn the unit on.2 Press and hold [OK], the yellow button andthe blue button on the remote control at thesame time for more than 5 seconds.4 Press and hold [OK] for more than 5 seconds.∫ Start-up BannerSelect whether to display the banner after turningon this unit. (> 15)This returns all values in the Setup menu and theOption menu to the default settings, except forsome settings of network, ratings, remote controlcode, on-screen language*, etc.* [Except[Australia[and[New[Zealand]Do you have the latest firmware installed?Panasonic is constantly improving the unit’sfirmware to ensure that our customers areenjoying the latest technology. (> 14)– Image disturbance when replacing 3D discs.– “00 RET” is displayed on the unit’s display.3 Press [1] (right) repeatedly on the remotecontrol until “06 FTO” is displayed on theunit’s display.General operation– “00 RET” is displayed on the unit’s display.3 Press [1] (right) repeatedly on the remotecontrol until “08 FIN” is displayed on the unit’sdisplay.