38Chapter 2 Basic Fax TransmissionVerification StampThis function confirms successful transmission or storageinto the memory by stamping at the bottom of eachsuccessfully transmitted original(s) with a small “x” mark.z The scanned document(s) are stamped after feeding through the ADF.z The standard setting of the Verification Stamp is “Off”. The stamp setting can be changed with the Function Parameter“04 Stamp (HOME)” (Fax/Email Settings > Fax Parameters). For instructions on how to change the standard setting,refer to Fax/Email Settings in the Operating Instructions (For Function Parameters) of provided CD-ROM.z The machine can be configured not to stamp the documents stored in the memory by changing the setting ofthe Function Parameter “28 Stamp at Memory XMT” (Fax/Email Settings > Fax Parameters). For instructionson how to configure the verification stamp, refer to Fax/Email Settings in the Operating Instructions (ForFunction Parameters) of provided CD-ROM.z The Verification Stamp function is available when scanning documents with the ADF.z Because the verification stamp cannot be deleted, be careful not to use the verification stamp whentransmitting important document(s).1 Place original(s) on the ADF.z Refer to Placing Originals (Facsimile/Internet Fax) in the Operating Instructions(For Basic Operations) of provided booklet.2 Press the Fax key.3 Select “Basic Menu”.4 Select “Verification Stamp”.5 Set “Quality Adj.” as required.z Refer to Setting Original Quality (see page30).6 Select “Address Book”, and thenselect a destination.z Refer to Entering a Destination (see page16).7 Press the Start key.The original(s) are stored into memory with afile number. Then starts dialling the telephonenumber.z The setting of the “Verification Stamp” isreturned to Off after the transmission iscompleted.Verification StampEx: ScanningDirection
