Panasonic DVD-CP67 Operating Instructions Manual

Also see for DVD-CV37: Operating instructions Quick manual Operating instructions Operating instructions Operating instructions

Connection to a television12to,ct:J»This page explains how to connect the unit to a television andthe powerful multi-channel audio lound on DVDs, you shouldBefore connection•Disconnect the AC power supply cord.• Refer to the television's operating instructions.set it up so you hear the audio through the television's speakers. To get the full benefit fromconnect an amplifier and speakers page 1 8)-TelevisionTo household AC outlet(AC 120 V, 60 Hz) AUDIO VIDEOIN INL (OK" <|> (Q)red white yellowAC powersupply cord(included)Audio/video cable(included)The illustration showsDVD-CP67 red wnite yellowDVD-CP67 1To enjoy progressive videoConnect to the component video (480p) input terminals on a televisioncompatible with this unit's copy guard system, (Video will not bedisplayed correctly if connected to an incompatible television.)In QUICK SETUP, set "Progressive Out" to "Enable" (• page 7).For your referenceAll televisions manufactured by Panasonic and that have 480p inputconnectors are compatible. Consult the manufacturer if you haveanother brand of television.Connect your unit directly to your television.Do not connect the unit through your video cassette recorder whensetting up your home entertainment system, because the picture maynot be played correctly due to the copy guard.S VIDEO OUT terminalThe S-video terminal achieves a more vivid picture than the VIDEOOUT terminal by separating the chrominance (C) and luminance (V)signals. (Actual results depend on the television.) TelevisionS video cable(not included)When making this connection, ensure you connect the audio cablesto the corresponding audio input terminals on the television.COMPONENT VIDEO OUT terminalConnection using these terminals outputs the color differencesignals (Pb/Ph) and luminance signal (Y) separately in order toachieve high fidelity in reproducing colors.•The description of the component video input terminals dependson the television or monitor (e.g. Y/Pb/Pr, Y/B-Y/R-Y, Y/Cb/Cr).Connect to terminals of the same color.•After making this connection, change the black level for a betterpicture (• page 16, Video—Black Level Control).* |DVD-CP67|These terminals can be used for either interlace or progressiveoutput and provide a purer picture than the S VIDEO OUTterminal. TelevisionVideo cable(not included)COMPONENTVIDEO INYPbPRWhen making this connection, ensure you connect the audio cablesto the corresponding audio input terminals on the television.Conserving powerThis unit consumes a small amount of power, even when it is turned offunplug it from the household AC outlet.The remote controlo11 »lnsert so the poles (+ and -) match those in the remote control.*Do not use rechargeable type batteries.2.5 W). To save power when the unit is not to be used for a long time,Do not:•mix old and new batteries,•use different types at the same time,•heat or expose to flame,•take apart or short circuit.•attempt to recharge alkaline or manganese batteries.•use batteries if the covering has been peeled off.Mishandling of batteries can cause electrolyte leakage which can damageitems the fluid contacts and may cause a fire.Remove if the remote control is not going to be used for a long period oftime. Store in a cool, dark place.UseAim at the sensor, avoiding obstacles, at a maximum range of 7 m (23 feet)directly in front of the unit.