Panasonic DVD-RP82 Operating Instructions Manual

Also see for DVDRP82 - DIG. VIDEO DISC PLAY: Operating instructions

The unit is auto~aticail~ @To conserve power: the unit automatically switches to standby after approximately 30 minutes in .4witched lo the standby mode. the stop mode. Turn the power back to ON.@The unit was switched io standbv bv the SLEEP timer. I I11No operations can be ~e~o~~a~ BCheck that the batteries are installed correctly. 8with the remote control. @The batteries are depleted: Replace them with new ones. I%@Point the remote control at the remote control signal sensor and operate. 8I Cannot select alt~rflat~v~ @This function is deoendent on software availabilitv. I - Ilanguages. @Try selecting from’the disc’s menu if one is available. 10~.~~~~~~~~~~~~ ::. “:. *,-,:j :,l “,::1‘a,, ,-II., i \ _ !.‘~. :l-l; ”No subtitles. SThis function is dependent on software availability.eSubtftles are cleared from the television. Display the subtitles.@This function is dependent on software availability. Even if a disc has a number of anglesrecorded, these angles may be recorded for specific scenes only.‘.‘,)_You have forgotten yotdr ratings @While stopped, press and hold [I -.password. on the unit until “Initialized” disappears from the television. Turn the unit off and on again.Reset all the settings to Factory All setltngs will return to the default values.Preset.The picture shown on thetalevision is not normat.{The aides of the picture are cutoff, the picture is stretchedhorizontally, or black bandsappear at the top and bosom ofthe screen.)@Some distortion is normal during SEARCM.@The screen may be disrupted briefly when you turn off the AUDIO ONLY feature.-8If ‘ disc is PAL system. The output is sound only.” is on the television, then you have loaded aPAL system DVD-Audio and only the audio portion of the disc can be played. T---.@Use the television to change the aspect to the correct one.If your television cannot change the asp& waft input is progressive, press[PROGRESSIVE OUT] so the indicator goes out. Output will now be interlace.@The 4:3 TV ZOOM function is on.aEnsure that the unit is connected directly to the television, and is not connected through a video10176cassette recorder.@Connect to the component video (48OP) input terminals on a television compatible with this unit’s 6CODVauard svstem. You cannot view proqressive video if vour televisi,on is not compatible.Picture fqualitv is Poor. acheck the settings in the On-Screen Menu Icons’ Picture Menu.@The unit and television are using different video systems.r PAL television.Use a multi-system or NTSC television.NThisbefApachachaTheareberecvidFraTheOn