Panasonic Diga DMR-EH585 Operating Instructions Manual

Contents

6RQT9059STEP 1 Connection≥Before connection, turn off all equipment and read the appropriate operating instructions.≥Select the connection pattern that matches your environment from pattern A–B. Confirm connections not listed below with yourdealer.≥Refer to “Additional connections” (➡ 67) for connection using other terminals and connection with other equipment.Using a 21-pin Scart cable≥You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television (➡ 38).≥You can enjoy high-quality viewing by connecting the unit to an RGB compatible television (➡ 82).[Required]setting] “AV1 Output” in the Setup menu (➡ 64)When the unit is not to be used for a long timeTo save power, unplug it from the household mains socket. This unit consumes a small amount of power, even when it is turned off[approx. 2 W (Power Save mode)]When “Power Save” is set to “On”, the “Quick Start” function does not work.A Connecting a televisionRFRFININRFRFOUTOUTAV2 (DECODER/EXT)AV1(TV)OPTICALDIGIDIGITALAL AUDIO OUUDIO OUT(PCM/BITSTREAM)(PCM/BITSTREAM)COMPONENTCOMPONENTVIDEO OUTVIDEO OUT S VIDEOVIDEOR-AUDIO-LPRPBYAC INOUTOUTAAV OUV OUTTVHF/UHFRF IN AV4321 2To the aerial Television’s rear panelAerialcableRF coaxial cable(included)This unit’s rear panelTo household mains socket(AC 220 to 240 V, 50 Hz)Fully wired 21-pin ScartcableAC mains lead(included)Connect only after all otherconnections are complete.Cooling fanConnecting a terminal otherthan the 21-pin Scart terminal(➡ 7, 67)B Connecting a television and digital/satellite receiver or decoderRFRFININRFRFOUTOUTAV2 (DECODER/EXT)AV1(TV)OPTICALDIGIDIGITALAL AUDIO OUUDIO OUT(PCM/BITSTREAM)(PCM/BITSTREAM)COMPONENTCOMPONENTVIDEO OUTVIDEO OUT S VIDEOVIDEOR-AUDIO-LPRPBYAC INOUTOUTAAV OUV OUTTAV543AVVHF/UHFRF IN21 2To the aerial Television’s rear panelAerialcableThis unit’s rear panelTo household mains socket(AC 220 to 240 V, 50 Hz)Fully wired 21-pin ScartcableAC mains lead(included)Connect only after all otherconnections are complete.Digital/satellite receiver ordecoder’s rear panel21-pin Scart cable[Required]setting]“AV2 Input” and “AV2 Connection” settings in theSetup menu (➡ 64)Cooling fanConnecting a terminal otherthan the 21-pin Scart terminal(➡ 7, 67)RF coaxial cable(included)Connect the unit directly to the televisionIf you connect the unit through an AV selectoror video cassette recorder to the television,video signal will be affected by copyrightprotection systems and the picture may notbe shown correctly.≥When connecting to a television with a built-in VCRConnect to the input terminals on the television side if there areboth television and VCR input terminals.TelevisionVCRThis unitDO NOT