Panasonic EB-X70 Service Manual

Also see for EBX70 - CELL PHONE: Operating instructions Operating instructions Technical information Service manual

OPERATING INSTRUCTIONSPMCD030901C8 Section 3 Issue 1Service Manual – 7 – Revision 03.6. IMEI and Software IdentificationTo check the IMEI number of the phone:Press: * # 0 6 #To identify the software version installed on the phone:Press: * # 9 9 9 9 # within five seconds of switching on.3.7. SIM Personalisation3.7.1 IntroductionSIM personalisation will limit the use of the telephone to a single SIM, a SIM supplied by one Network / Sub-network / ServiceProvider or a SIM purchased by a company (corporation). If a personalised handset contains a SIM that is from a differentsource, it will display the message “SIM ERROR” when switched on. This personalisation is sometimes referred to as SIMlock or SIM latch.3.7.2 TestingTo test a personalised handset when the user has not supplied the SIM, a SIM configured for test purposes (e.g. test SIM orsoft SIM) should be used. The mobile will recognise that the SIM is for testing purposes only and operate as normal.3.7.3 Personalisation FunctionPersonalisation is activated during manufacture. Enabling / disabling is available by entering a special key sequenceimmediately after power on. Once the enable / disable menu is shown it is possible to select the type of personalisation. Whenpersonalisation is enabled it is only possible to disable it if the mobile contains a SIM and the 8 or 16 digit Control Key (CK) isknown. For security reasons, when CK is enabled, it cannot be read by the user.There are two special key sequences to enter the enable / disable menu:3.7.4 Disabling ProcedureCan only disable personalisationCan both enable and disable personalisationNotesKey Sequence5 2 8 2 47 4 61. Press or2. Scroll up / down to select:"SIM" for SIM Personalisation"Network" for Network Personalisation"Sub-Network" for Sub-Network Personalisation"ServiceProvider" for Service Provider Personalisation, or"Corporate" for Company Personalisation.3. Press4. Enter the 8 or 16 digit Control Key and press5. Confirm by entering the 8 or 16 digit Control Key again and pressThe display will confirm which type of Personalisation has been disabled.5 2 8 2 47 4 6