Panasonic EY6406 Instruction Manual

Also see for EY6406 - CORDLES DRILL&DRIVER: Instruction manual Service manual Service manual Service manual

• Charging will not start if the batterypack IS warm (for example, immedi¬ately after heavy-duty o^ration).The orange standby lamp will be lituntil the battery cods down. Chargingwill then begin automatically.4. When charging is completed, the charg¬ing lamp win start flashing i^dly.5. When in any of the conditions that bat¬tery pack is too cod, or the battery packhas not been used for a long time, thecharging lamp starts flashing slowly toindicate protective charging.Protectivecharging takes longer to fully chargethe battery pack, than the standardcharging time. (Max. charging time isapprox. 90 minutes).* If a fully charged battery pack isinserted into the charger again, thecharging lamp may light up and thenflash slowly. After several minutes,the charging lamp may flash quicklyto indicate the charging is completed.6. If the charging lamp does not lightimmediately after the charger isLAMP INDICATIONSplugged in, or if after the standardcharging time the lamp does not go off,consult an authorized dealer.Note: * When charging a cool batterypack (below 5*C) in a warmplace, leave the battery pack atthe place and wait for morethan one hour to warm up thebattery to the level of theambient temperature. (Batterypack may not be fully charged.)* Cod down the charger whencharging more than twobattery packs consecutively.* Do not insert your fingers intocontact hole, when holdingcharger or any other occasions.CAUTION: * Do not use power sourcefrom an engine generator.« Do not cover vent holeson the charger and thebattery pack.oCQCFlashingUt• •Rashtng quicklyFlashing stowtyLitFlashing(I)-■►a—•♦CD-1--XCDCharger is plugged into a wall outlet. Readyto charge.Now chargingCharging is completedProtective chargingBattery pack is warm. Charging will beginwhen temperature of battery pack drops.Charging is not possible. Clogged withdust or malfunction of the battery pack.MAINTENANCEUse only a dry. soft cloth for wiping theunit. Do not use a damp cloth, thinner,benzine, or other volatile solvents forcleaning.ATTENTION:The nickel cadmium battery you havepurchased is recyclable. At the end of it’suseful life, under various state and locallaws, it is illegal to dispose of this batteryinto your municipal waste stream. Pleasecall 1-800-8-BATTERY for information onhow to recycle this battery.-9-

/ 11

Related manuals for Panasonic EY6406 - CORDLES DRILL&DRIVER