Panasonic HC-V520P Service Manual

52.3. Caution for AC Cord(For EB/GC)2.3.1. Information for Your SafetyIMPORTANTYour attention is drawn to the fact that recording of pre-recorded tapes or discs or other published or broadcastmaterial may infringe copyright laws.WARNINGTo reduce the risk of fire or shock hazard, do not exposethis equipment to rain or moisture.CAUTIONTo reduce the risk of fire or shock hazard and annoyinginterference, use the recommended accessories only.FOR YOUR SAFETYDO NOT REMOVE THE OUTER COVERTo prevent electric shock, do not remove the cover. No userserviceable parts inside. Refer servicing to qualified servicepersonnel.2.3.2. Caution for AC Mains LeadFor your safety, please read the following text carefully.This appliance is supplied with a moulded three-pin mains plugfor your safety and convenience.A 5-ampere fuse is fitted in this plug.Should the fuse need to be replaced please ensure that thereplacement fuse has a rating of 5 amperes and it is approvedby ASTA or BSI to BS1362Check for the ASTA mark or the BSI mark on the body of thefuse.If the plug contains a removable fuse cover you must ensurethat it is refitted when the fuse is replaced.If you lose the fuse cover, the plug must not be used until areplacement cover is obtained.A replacement fuse cover can be purchased from your localPanasonic Dealer.If the fitted moulded plug is unsuitable for the socket outlet inyour home then the fuse should be removed and the plug cutoff and disposed of safety.There is a danger of severe electrical shock if the cut off plug isinserted into any 13-ampere socket.If a new plug is to be fitted please observe the wiring code asshown below.If in any doubt, please consult a qualified electrician.2.3.2.1. ImportantThe wires in this mains lead are coloured in accordance withthe following code:As the colours of the wires in the mains lead of this appliancemay not correspond with the coloured markings identifying theterminals in your plug, proceed as follows:The wire which is coloured BLUE must be connected to the ter-minal in the plug which is marked with the letter N or colouredBLACK.The wire which is coloured BROWN must be connected to theterminal in the plug which is marked with the letter L or colouredRED.Under no circumstances should either of these wires be con-nected to the earth terminal of the three pin plug, marked withthe letter E or the Earth Symbol.2.3.2.2. Before UseRemove the Connector Cover as follows.2.3.2.3. How to Replace the Fuse1. Remove the Fuse Cover with a screwdriver.2. Replace the fuse and attach the Fuse cover.Blue NeutralBrown Live