12SQT0644 (ENG)The unit can record still pictures or motion pictures to an SD card or built-in memory. To record to anSD card, read the following.Cards that you can use with this unitUse SD cards conforming to Class 4 or higher of the SD Speed Class Rating for motionpicture recording.When recording with [Backup for Twin Camera] set to [ON], use an SD card conforming toClass 10 of the SD Speed Class Rating. If the SD Speed Class Rating is lower than Class 10,recording may suddenly stop.≥ Operation is not guaranteed for all SD cards.≥ Keep the Memory Card out of reach of children to prevent swallowing.Inserting/removing an SD cardWhen using an SD card not from Panasonic, or one previously used on other equipment, for the firsttime on this unit, format the SD card. (l 23) When the SD card is formatted, all of the recorded datais deleted. Once the data is deleted, it cannot be restored.Caution:Check that the access lamp has gone off.PreparationRecording to a cardPlease confirm the latest information about SD Memory Cards/SDHC Memory Cards/SDXCMemory Cards that can be used for motion picture recording on the following website.http://panasonic.jp/support/global/cs/e_cam(This website is in English only.)1 Open the SD card cover and insert (remove) the SD card into (from) thecard slot B.≥ Face the terminal side C in the direction shown in the illustration and press it straight in as faras it will go.≥ Press the centre of the SD card and then pull it straight out.2 Securely close the SD card cover.≥ Securely close it until it clicks.Access lamp[ACCESS] A≥ When this unit is accessingthe SD card or built-inmemory, the access lamplights up.