Panasonic HC-X1000 Basic Operating Instructions Manual

Also see for HC-X1000: Operating instructions Owner's manual

Panasonic HC-X1000 Basic Operating Instructions Manual Manual pdf 38 page image

38SQT0478∫ It is not a malfunction in following casesPlease refer to “Operating Instructions (PDF format)” for details.OthersTroubleshootingThe lens, the viewfinder orLCD monitor fog up.≥ This is due to condensation. It is not a malfunction. Pleaserefer to page 6.Object seems to be warped. ≥ Object seems to be warped slightly when the object movesacross the image very fast, but this is because the unit is usingMOS for the image sensor. This is not a malfunction.Problem Check pointsThis unit cannot be turnedon.This unit does not stay onlong enough.Battery runs down quickly.≥ Charge the battery again to ensure it is sufficiently charged.(l 16)≥ In cold places, the battery using time becomes shorter.≥ The battery has a limited life. If the operating time is still tooshort even after the battery is fully charged, the battery hasworn out and needs to be replaced.This unit cannot beoperated though it isturned on.This unit does not operatenormally.≥ Remove the battery or AC adaptor, wait about 1 minute andthen reconnect the battery or AC adaptor. Then about1 minute later, turn on the unit again. (Conducting the aboveoperation while the media is being accessed may damage thedata on the media.)≥ If normal operation is still not restored, detach the powerconnected, and consult the dealer who you purchased thisunit from.The unit arbitrarily stopsrecording.≥ Use an SD card that can be used for motion picture recording.(l 19)≥ The recordable time may have shortened due to thedeterioration of the data writing speed or repeated recordingand deletion. Using the unit, format the SD card. (l 25)Colour or brightness ofthe image changes, or youmay see horizontal bars inthe image.The LCD monitor flickersindoors.≥ Colour or brightness of the image may change, or you maysee horizontal bars in the image when the object is recordedunder fluorescent light, mercury light or sodium light, etc., butthis is not a malfunction.≥ Record images in Intelligent Auto Mode or adjust the shutterspeed to 1/50, 1/60 or 1/100.≥ Adjust the Synchro Scan shutter speed.