Panasonic HDC-SD800P Owner's Manual

Also see for HDC-SD800P: Owner's manual Owner's manual

Contents

Panasonic HDC-SD800P Owner's Manual Manual pdf 43 page image

Theunitisputintorecordingpauseapprox.1secondwhentheunitisturnedonwiththemodesetto_ or O.• Depending on the recording conditions, start time may be longer than 1 second.• In the Quick power on mode, the zoom magnification becomes 1 ×.This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.• When in Quick start standby mode about 80% of the power used in Recording pausemode is being consumed, so the recording time will be reduced,• Quick start will not work if there is no SD card inserted.• Change the mode to _ or O.1 Set [QUICK START] to [ON].2 Close the LCD monitor while the mode is set tomlR or _.The status indicator O flashes green and the unit goes intoQuick start standby mode.• The lens cover does not close.3 Open the LCD monitor.The status indicator O lights red and the unit is put intorecording pause.• Quick Start Standby Mode is canceled ifabout 5 minutes have elapsedmode is set to []• Depending on the recording conditions and menu settings, time for Quick start may belonger than 0.6 seconds.• It may take some time for Automatic white balance to adjust.• In the Quick Start Mode, the zoom magnification becomes 1 ×.• If [ECONOMY] (-) 42) is set to [5 MINUTES] and the unit automatically goes into QuickStart Standby Mode, close the LCD monitor and then open it again.• Turn the unit off using the power button.• Quick start standby mode cannot be released by the remote control.Please refer to page 47.43VQT3K35