103VQT2W75With a PCSetup2 Connecting to a PC≥ Connect this unit to the PC after the software applications are installed.≥ Remove the supplied CD-ROM from your PC.A USB cable (supplied)1 Connect this unit to the AC adaptor.≥ It is possible to use it connected to the PC with the batteries only, but you will not be able towrite data into the unit.≥ Connect with the AC adaptor when using the Conversion assist function.2 Turn on the unit.≥ This function is available in all modes.3 Connect this unit to a PC.≥ The USB function selection screen will appear.4 Touch [PC] on the screen of this unit.≥ The Smart wizard screen is automatically displayed when HD Writer AE 2.6X is installed.≥ This unit is automatically recognised as an external drive of the PC. (l 105)≥ When you select an option other than [PC], reconnect the USB cable.≥ When using the battery, the LCD monitor turns off after about 5 seconds. Touch the screento turn the LCD monitor on.≥ Do not use any other USB cables except the supplied one. (Operation is not guaranteedwith any other USB cables.)≥ When the unit is connected to a PC it cannot be turned off.Disconnect the USB cable, before turning this unit off.≥ Do not disconnect the USB cable or the AC adaptor while the access lamp is on or cardaccess icon ( ) appears on the unit screen.≥ When performing reading/writing between a PC and an SD card, be aware that some SDcard slots built into PCs and some SD card readers are not compatible with the SDHCmemory card or SDXC memory card.≥ When using an SDXC Memory Card, check the following support site.http://panasonic.net/avc/sdcard/information/SDXC.html
