12VQT2W55Quick Guide∫ Inserting the batteryInstall the battery by inserting it in thedirection shown in the figure.A Insert the battery until it clicks and locks.∫ Charging the batteryA DC input terminal1 Connect the AC adaptor to the DC inputterminal.2 Connect the AC cable to the ACadaptor, then the AC outlet.≥ The status indicator will flash red at aninterval of 2 seconds, indicating thatcharging has begun.It will turn off when the charging iscompleted.∫ Inserting/removing an SD card1) Open the LCD monitor.2) Open the SD card cover and insert(remove) the SD card into (from) thecard slot B.≥ Face the label side C in the directionshown in the illustration and press itstraight in as far as it will go.≥ Press the center of the SD card and thenpull it straight out.3) Securely close the SD card cover.≥ Securely close it until it clicks.∫ Turning the unit on/offTurning the unit on and off with thepower buttonPress the power button to turn on the unit.A The status indicator lights on.≥ To turn off the unit, hold down the powerbutton until the status indicator goes off.Turning the unit on and off with the LCDmonitorUnit is turned on when the LCD monitor isopened, and unit is turned off when it is closed.∫ To turn on the unitA The status indicator lights on.Access lamp [ACCESS] A≥ When this unit is accessing the SDcard, the access lamp lights up.
