Panasonic HDC-TM10 Operating Instructions Manual

Also see for HDC-SD10: Operating instructions Specification sheet Operating instructions Operating instructions

Panasonic HDC-TM10 Operating Instructions Manual Manual pdf 10 page image

10VQT2D12 (ENG)PreparationSetup1 Power supply∫ About batteries that you can use with this unitThe battery that can be used with this unit is VW-VBG070/VW-VBG130/VW-VBG260/VW-VBG6.≥ This unit has a function to distinguish the batteries that can be used, and the batteries(VW-VBG070/VW-VBG130/VW-VBG260/VW-VBG6) are compatible with this function. (Thebatteries that are not compatible to this function cannot be used.)≥ To use the VW-VBG260/VW-VBG6 for this unit, the battery pack holder kit VW-VH04 (optional) is required.Important:If the DC cable is connected to the AC adaptor, then the battery will not charge. Remove the DCcable from the AC adaptor.1 Connect the AC cable to the AC adaptor and the AC outlet.2 Insert the battery into the AC adaptor by aligning the arrows.It has been found that counterfeit battery packs which look very similar to the genuineproduct are made available to purchase in some markets. Some of these battery packs arenot adequately protected with internal protection to meet the requirements of appropriatesafety standards. There is a possibility that these battery packs may lead to fire or explosion.Please be advised that we are not liable for any accident or failure occurring as a result of useof a counterfeit battery pack. To ensure that safe products are used we would recommendthat a genuine Panasonic battery pack is used.Charging the batteryWhen this unit is purchased, the battery is not charged. Charge the battery before using thisunit.Charging lamp [CHARGE] ALights up:Charging (Battery charging time: l 12)Goes off:Charging completedFlashing:Make sure that the terminals of the battery or theAC adaptor are not exposed to dirt, foreign objectsor dust, then reconnect them properly.