Panasonic KV-S2087 Operating Manual

Contents

Panasonic KV-S2087 Operating Manual Manual pdf 50 page image

6.2.4 Cleaning ModeCleaning Mode can be used to help cleaning the conveyor rollers. During Cleaning Mode, the conveyorrollers rotate a small amount every time the Start/Stop button on the scanner is pressed. So, you do nothave to rotate the conveyor rollers by using your fingers in order to clean the entire surface of each roller.Notice• Do not touch the conveyor rollers while they are rotating.• Use Cleaning Mode only to clean the conveyor rollers.1. Close the ADF door.2. Plug in the power cord and connect the USB cable.3. Press the power button to turn ON the unit’s power.4. Start the User Utility.5. Select Cleaning Mode in User Utility.6. Press the ADF door release, and open the ADF door.7. Enter Cleaning Mode in User Utility.8. Clean the conveyor rollers.a. Use the Roller Cleaning Paper (page 9) to wipe the dirt from the surfaces of the conveyor rollers.b. Press the Start/Stop button on the scanner to rotate the conveyor rollers a small amount.c. Repeat these steps until all surfaces of all conveyor rollers are cleaned.9. Exit Cleaning Mode after cleaning is completed.6.2.4 Cleaning Mode50