7.2.2. Cleaning-1 (Main)According to the instructions in following figures Fig.7.2.2-1 and Fig.7.2.2-2, wipe off or blow off the dirt from each surface of thefollowing parts so as to realize a high-performance on the scanning condition.(Fig.7.2.2-1): Cleaning Parts and ActionMaintenance Parts *1 Action Code Action CommentsPaper Feed Roller C Clean each surface with the accessoryRoller Cleaning Paper or Model KV-SS03(Option: Roller Cleaning Paper) to wipe offthe dirt around its surface.1. How to deal with the RollerCleaning Paper and others.→ See Note *2 .2. Cleaning position→ See Fig.7.2.2-2.After cleaning the Paper Feed,Separation, and Retard Rollers, execute“Clear Counter” for cleaning roller withService Utility. (See 9.3.)Separation Roller CRetard Roller CDrive Roller 1 CDrive Roller 2 CDrive Roller 3 CConveyor Roller 1 CConveyor Roller 2 CConveyor Roller 3 CFree Rollers CImage Sensor Cover (F) C(B) CPaper Sensor B Blow off the dirt on each surface with theaccessory Blower.1. How to use the Blower→ See Note *3 .2. Cleaning position→ See Fig.7.2.2-2.Waiting Sensor (Board) BSkew (L) Sensor (on theWAITING SENSOR Board)BSkew (R) Sensor (Board) BStarting Sensor (Board) BPaper Jam Sensor (Board) BDouble Feed Detector (G) BDouble Feed Detector (R) BReflector Sheets BNote: *1Action Code shows cleaning method as follows.C: Clean each surface with the accessory Roller Cleaning Paper or Model KV-SS03 (Option: Roller Cleaning Paper)B: Blow off each surface with the accessory Blower.Note: *2Roller Cleaning Paper· Open the bag by the dotted line and take out the Roller Cleaning Paper.· If the opened bag is left open for a long period of time before using it, the alcohol will evaporate. Use the RollerCleaning Paper immediately after opening the bag.· The Roller Cleaning Paper (Model No. KV-SS03) is available via sales route.Note: *3How to clean sensor (detectors) and reflectors.Remove the brush from the accessory Blower and blow off the dirt with the blower.24KV-S3065CLSERIES / KV-S3065CWSERIES