KV-SSM100 /KV-SS1100 NETWORK SCANNER ADAPTERQUICK SETUP GUIDEThis guide is intended for the network administrator/solutions engineer responsible for setting up the KV-SSM100/KV-SS1100. It contains key steps to connect the adapter to a Panasonic Scanner, and then perform basic Scan to Folderoperations. For instructions on how to set up Scan to Email, Scan to Fax, Scan to Bluetooth and Scan to Printer, pleaserefer to the KV-SSM100/KV-SS1100 Network Scanner Adapter Administrator’s Guide.STEP 1: PERFORM INITIAL CONFIGURATION1. Press [Power] button to turn adapter On.2. Press [Configure Device Now].3. Enter Admin Password of your choice.4. Re-enter to Confirm password.5. Press [Enter] to save password.Note:n Password must be at least six (6) characters.n Password is case sensitive.n Password can be changed after configuration.6. Continue with Network Settings…Network SettingsSelect type of network connection:1. Wired Settings (default) – Adapter will obtain IP address fromDHCP server, and auto-populate remaining fields. Deselectcheckbox to manually input IP address settings. Press [Next], andcontinue with Shared Folder Configuration (below).Note: Ethernet cable must be attached to adapter from networkswitch in order for IP address to be obtained.2. Wireless Settings: Select [Wireless]. Connect to WiFi network bypressing [Wireless Discovery]. SSID field should be automaticallypopulated. If not, manually input SSID. When WiFi networksdisplay, select/highlight network, and then press [Select]. EnterSecurity Key, and press [Next], and continue with Shared FolderConfiguration…Shared Folder ConfigurationOnce Network Settings are complete, the Share Management screenappears, where you can use Network Discovery to search for publicWindows shares within the network. Note: To manually set up UNC orFTP folder paths, use Manual Setup instructions (see page 2).Network Discovery1. On Share Management screen, press [Add].2. On Add Share screen, press [Search].Important: If no network shares are discovered, i.e., Searchscreen is blank, manual setup is required, as the computer is likelypassword protected, in which case you must enter the folder pathand login credentials manually. (See next page.)3. On Network Discovery screen, select workgroup/domain and PCwhere shared folders are located.4. Press [Select Share].5. Enter Friendly Name (required).Note: You cannot add two shares with the same Friendly Name.BEFORE YOU BEGINConfirm the following: Power cable is connected to adapter.1. Connect AC adapter to DC-in jack of adapter.2. Connect AC adapter to power cord.3. Plug power cord into electrical outlet. Panasonic scanner is installed.1. Connect USB cable from scanner to adapter. Connection method is known:Wired: Cable is connected from adapter’s Ethernet portto network switch/router.Wireless: Ensure that wireless router is workingcorrectly and that there is no network (Ethernet) cableattached to the adapter. Have the following informationavailable:n SSID (e.g., NETGEAR62)n Security Mode (Open, WEP, WPA Personal, WPA2Personal). Note: WPA Enterprise and WPA2 EnterpriseWi-Fi networks are not supported. Network is configured for folder sharing.n Ensure that Network File and Folder Sharing settingsand permissions are established.n To enter FTP server addresses or UNC paths, tomanually locate shared folders, have path informationavailable.n If access to shared folders requires authentication (orfolder is on an FTP server), you must manually locatethe folders. Know your login credentials.