Panasonic KX-FP181E Operating Instructions Manual

Answering DeviceRemote OperationNotice of Remote OperationFold here1. Call your unit.2. Enter the remote operation IDduring the greetingmessage.l The new messages will beplayed automatically.l If there are no newmessages, wait for 4seconds. All the messageswill be played back.3. Press the remote commandkey(s) within 10 seconds (seethe reverse side).l The remote operation isavailable only from a touchtone telephone when the unitis in the TAD/FAX mode.l When the unit is in the TELmode, call your unit and waitfor 10 rings. Enter the remoteoperation ID within 8 secondsand wait for 3 seconds. Theunit will switch to the TAD/FAXmode.l When you press a key, pressfirmly.l To send a document, press. When a fax tone isheard, start transmission.959Remote Operation (KX-FP185 only)The following operations can be performed from a remote location using a touch tone telephone.Program the remote operation ID (feature #11 on page 66) and set the unit to the TAD/FAXmode before going out (p. 52).Remote operation cardPlease cut out and carry this card for assistance when using the remote operation.Operating from a remote location!Note:l During remote operation, the unit will stop and two beeps will be heard in the following conditions:— 2 minutes 40 seconds after your unit answered.— Every 2 minutes 40 seconds after pressing any command key.To listen to further messages, press within 10 seconds after hearing the two beeps.8Stops re-recording of a greetingmessageErases a specific messageErases all messagesChanges to the TEL modeTurns ON message transferTurns OFF message transferTurns ON pager callTurns OFF pager callRemote commandDial key Page Dial key Remote command PageSkips the greeting messageRepeats a messageSkips a messageNew message playbackAll message playbackRe-records a greeting messageContinues operation616060606061Seenote 8 48 38 28 18 0549 61616161616161618754210