Panasonic KX-FP85 Service Manual

Also see for KX-FP85: Operating instructions Service manual

Contents

Code Function Set Value Default RemoteSetting591 FAX auto redial line disconnection time set 001~999sec 045 OK592 CNG transmit select 1:OFF / 2:ALL / 3:AUTO ALL OK593 Time between CED and 300 bps 1:75ms / 2:500ms / 3:1sec 75ms OK594 Overseas DIS detection 1:1st / 2:2nd 1st OK595 Receive error limit value 001~999 100 OK596 Transmit level set -15~00dBm 10 OK598 Receiving Sensitivity 20~48 43 OK599 ECM Frame size 1:256/ 2:64 256byte OK602 Warning list printing 1:ON / 2:OFF ON OK717 Transmit speed select 1:9600/ 2:7200/ 3:4800/ 4:2400 9600bps OK718 Receive speed select 1:9600/ 2:7200/ 3:4800/ 4:2400 9600bps OK719 Ringer off in TEL/FAX mode 1:ON / 2:OFF ON OK721 Pause tone detect 1:ON / 2:OFF ON OK722 Redial tone detect 1:ON / 2:OFF OFF OK731 CPC mode 1:A / 2:B / 3:OFF A OK732 Auto disconnect 1:350ms / 2:1800ms / 3:OFF 350msec OK745 Power on film feed 1:ON / 2:OFF ON OK763 CNG detect time for friendly reception 1:10s / 2:20s / 3:30s 30s OK771 T1 timer 1:35s / 2:60s 35s OK774 T4 timer 00~99 x 100ms 00 OK775 Monitoring of message transfer 1:ON / 2:OFF OFF OK784 Voice prompt 1:Start --------- NG815 Sensor & VOX test --------- --------- NG841 Digital SP-Phone RX & TX check 1:SP-Phone --------- NG852 Print test pattern --------- --------- NG853 Top margin 1~9 --------- OK854 Left margin 1~8 --------- OK880 History list 1:Start --------- NG881 Journal 2 1:Start --------- NG882 Journal 3 1:Start --------- NG890 TEL/FAX ring back tone 1:ON / 2:OFF ON OK895 TEL/FAX Receive mode 1:TAD/FAX / 2:FAX FAX OK991 Setup list 1:Start --------- OK994 Journal list 1:Start --------- OK995 Journal 2 list 1:Start --------- OK996 Journal 3 list 1:Start --------- OK998 History list 1:Start --------- OK999 Service list 1:Start --------- OKOK means "can set".NG means "can not set".Note:Refer to 2.4.4 SERVICE FUNCTION TABLE (P.91) for descriptions of the individual codes.Example:If you want to set value in the "004 Transmission report mode", press the dial key number 1,2 or 3 corresponding to the SetValue you want to select. (1:ERROR/2:ON/3:OFF)65KX-FP85