Panasonic KX-HCM250 Operating Instructions Manual

Also see for KX-HCM250: Operating instructions

Contents

Operating Instructions[For assistance, please call: 1-800-272-7033] 119Green indicatorcontinuesblinking.Internal Failure of the server or the congestion on the networktraffic when using DHCP may prevent Network Camera fromgetting the IP address. Ask the network administrator or your ISP.Orangeindicatorcontinuesblinking.Orange indicator blinks when updating firmware on page 91. Whenthe Update Firmware failed, refer to page 120.Red indicatorcontinuesblinking.If you cannot access Network Camera, the Network Camerahardware may be defective. Call our customer call center.Image Transferon e-mail or FTPdoes not work.• Default Gateway and DNS server address should be set up onNetwork window on page 58.• If FTP does not work properly, ask your ISP or networkadministrator about the transferring mode of FTP server.[Passive Mode] or [Active Mode] is available.• Select [One Time] for Login Timing when transferring imagesby FTP in short duration time.Timer modetransfers olderimages.Short interval of Image Buffer Frequency makes Network Cameratransfer the older images. Set the interval long enough to transferthe images. Buffered Image screen enables you to check thissetting.Wirelesscommunicationdoes not work.• Signal strength is weak. Change the location of NetworkCamera or get rid of the obstacle around Network Camera.• SSID and Encryption setting of Network Camera are differentfrom those of the wireless router or the wireless LAN card ofPC. SSID and Encryption setting must be identical betweenNetwork Camera and wireless router.• Draw out the Ethernet cable and reconnect the AC adaptor forNetwork Camera to recognize the Wireless Communicationmode.Wiredcommunicationdoes not work.Reconnect AC adaptor for Network Camera to recognize thechange from wireless to wired communication or vice versa.About Network Camera SetupProblem Cause and Remedy