Setup overview1 Battery chargingMake sure the battery is fully chargedbefore you setup.2 Power onTurning the power on for the camera.3 Downloading the applicationDownload the [HomeHawk] app to yourmobile device.4 Connection for access pointConnect the AC adaptor and Ethernetcable to the access point.5 Initial setupMake sure you can access the systemusing your mobile device.6 RegistrationRequired only if the camera waspurchased separately (i.e., not as part ofa bundle).7 Confirm the installation areaRead the information in this document toconfirm that the desired installation areais suitable to proper operation.8 InstallationInstall the camera in the desired location.Battery charging forcamerasR This camera has an internal rechargeablebattery.R Remove the camera from the wall beforecharging (page 27).R Turn the camera off before charging thebattery. If the camera is turned on whilecharging, it may take longer to charge.R Make sure to charge the battery indoorsand in a dry location.R Charge the battery in a location with atemperature between 5 °C and 40 °C. Thebattery cannot charge in locations outsideof these temperatures.Front door cameraCharge for about 8 hours.1 Slide the lock key (A).2 Open the button cover (B).3 Insert the USB cable (C) into themicro-USB connector.1 23115.0 V, 1.0 A or higher power sourceOutdoor cameraCharge for about 8 hours.1 Open the micro-USB jack cover (A).2 Insert the USB cable (B) into themicro-USB connector.12122 For assistance, please visit http://shop.panasonic.com/supportSetup