Panasonic KX-HNS101 Installation Manual

Also see for KX-HNS101: Quick setup User guide Installation guide Installation guide

Contents

Panasonic KX-HNS101 Installation Manual Manual pdf 11 page image

Temporary placementBefore installing the window/door sensor, temporarily place it in the desiredlocation and confirm that it operates properly by pressing M N.Important:R Attach the sensor unit to the window frame or door frame, and attach themagnet unit to the window or door.R The window/door sensor will not operate properly if the “ ” marks are too farapart or are not pointing toward each other.R Attach both units so that the “ ” marks point toward each other and are within25.4 mm (1 inch) of each other.Confirming proper operationAfter temporarily placing the window/door sensor in the desired location, pressM N while the window or door is closed. The window/door sensor’s LED indicatorlights as follows.Indicator StatusGreen, lit The installation position is correct.Red, lit The “ ” marks on the sensor unit and the magnet unitare too far from each other. Re-attach the sensor unitand the magnet unit so that they point directly at eachother and are no more than 25.4 mm (1 inch) apart.Red, blinking The sensor unit is out of range of the hub. Refer to theinformation on page 10.Note:R Depending on the condition and material of the surface where the sensor unitand magnet unit are installed, the LED indicator may light in red even if the “ ”marks point directly at each other and are no more than 25.4 mm (1 inch) apart.For assistance, please visit http://shop.panasonic.com/support 11SetupHNS101_(en_en)_0616_ver.130.pdf 11 2015/06/16 22:24:10