Testing the motionsensorYou can observe the motion sensor’sLED indicator and test the performanceof the motion sensor.1 Press M N.2 Move to an area near the motionsensor.3 While moving near the motionsensor, observe the LED indicator.R When motion is detected, theLED indicator lights in red.4 Note the areas where movementis detected.5 Press M N again.Adjusting the sensorsensitivityYou can use the MHIGHN/MLOWN switch(page 7) to adjust the sensor’ssensitivity. If the sensor often makesincorrect detections, such as in areaswith frequent and substantialtemperature fluctuations, set the switchto the MLOWN position.Note:R When the switch is in the MLOWNposition, the sensor detection rangeis reduced by about half (comparedto when the switch is in the MHIGHNposition).Features availablewhen using the[Home Network] appSome of the motion sensor’s featuresthat are available when using the[Home Network] app are listed below.For more information, refer to theUser’s Guide (page 14).– Security systemYou can use the app to arm anddisarm the security system, confirmthe current status of the sensor, andview a log of previous securityevents.– Home controlYou can configure the motion sensorto trigger other system events, suchas camera recording, turning on anelectric device (such as a lamp), etc.(Appropriate device required.)– Telephone alertYou can configure the system to calla preprogrammed phone numberwhen the motion sensor is triggered.Accessing the User’sGuideThe User’s Guide is a collection ofonline documentation that helps youget the most out of the [HomeNetwork] app.1 iPhone®/iPad®Tap in the app’s home screen.Android™ devicesTap or press your mobiledevice’s menu button in the app’shome screen.2 Tap [User’s Guide].14 For assistance, please visit www.panasonic.com/supportAppendix