Panasonic KX-HNS107 Installation Manual

Also see for KX-HNS107: Installation guide

Contents

Panasonic KX-HNS107 Installation Manual Manual pdf 13 page image

Mounting the sensorIn most cases, you can mount thesensor to the garage door usingdouble-sided tape. In some cases,such as when mounting the sensor to awooden surface, you can use screws.Installation precautionsR Observe the following to avoid therisk of falling, which could causeinjury or damage to property.– Mount the sensor on a stablesurface where the sensor will beadequately supported.– Do not mount the sensor onplywood less than 25.4 mm(1 inch) thick.R Install the sensor on the inside of thegarage door.R Mount the sensor near the top of thegarage door. Additionally, werecommend mounting the sensornear the left or right edge of thegarage door, so that the sensor isnot directly above the car when thegarage door is open.Securing with double-sidedtapeImportant:R Make sure the surfaces of themounting adaptor and theinstallation area of the garage doorare clean and dry before applyingdouble-sided tape. Take particularcare to remove any oil or grime thathas accumulated on the garagedoor.R Install the sensor on a smooth areaof the garage door. Ideally thereshould be no pits or grooves deeperthan 0.5 mm (0.02 inches).R Once you have used thedouble-sided tape, do not reuse it.R When mounting the sensor in coldtemperatures, observe the followingto ensure optimal adhesion.– Affix the double-sided tape to themounting adaptor indoors, whenthe tape and the adaptor are atroom temperature.– Use a hair dryer or other low-heatemitting device to warm theinstallation surface of the garagedoor immediately prior toadhesion, otherwise adhesionmay be poor and the sensor mayfall.For assistance, please visit http://shop.panasonic.com/support 13SetupHNS107_(en_en)_0120_ver.101.pdf 13 2017/01/20 21:11:39