Panasonic KX-NS1000 Getting Started

Also see for KX-NS1000: User manual Installation manual User guide Installation manual Guide

Panasonic KX-NS1000 Getting Started Manual pdf 28 page image

4.1 Programming the PBX4.1.1 Easy Setup WizardIn the Easy Setup Wizard, you will set up the mandatory settings required for the PBX.When you log in to Web Maintenance Console for a PBX that is in its initialised, factory default state, the EasySetup Wizard for that PBX will launch automatically. You must log in using the Installer level account nameand password.– The Installer level account name is "INSTALLER".– The default Installer level account password is "1234".1. After Easy Setup Wizard launches, select a language, and then click Install.2. In Location Setting:a. Select a PBX Type:• Master: Select for a PBX that will be registeredas the Master unit of One-look network. Alsoselect for a stand-alone PBX that will not be usedin a One-look network.• Slave: Select for a PBX that will be registered asa Slave unit of a One-look network. If Slave isselected, go to step 2-d below.Note• If the Master unit is located on a differentLAN than the Slave unit being registered, theSlave unit will not be able to automaticallydetect the Master unit for registration. The IPaddress of the Master unit must be specified.Enter the IP address of the Master unit in Iflocated on different network from MasterPBX.• For information about stand-alone PBXs andPBXs in a One-look network, refer to"2.1.1 System Configurations" in theInstallation Manual.b. Select a Suffix Code*1 from the drop-down list ifMaster is selected for PBX Type.c. Select an Area*1 from the drop-down list if Master isselected for PBX Type.d. Click Next.NoteIf Suffix Code is changed from its default value, a notice about restarting the PBX is displayed. ClickOK to restart the PBX. After the PBX restarts, start Web Maintenance Console again (refer to"3.3 Starting Web Maintenance Console"). When you start the Easy Setup Wizard again, you will startfrom step 3, below.*1 For information about Suffix Codes and Areas to select, refer to "7.6 PBX Region Suffix Codes and Areas" in the InstallationManual.28 Getting Started4.1.1 Easy Setup Wizard