IP Network SettingsTo properly connect the unit to an IP network, thefollowing settings must be set to match the settings ofthe IP network. Consult your system administrator forthe appropriate settings.– IP address mode: Automatic (DHCP) or manual(static) IP address assignment (default: static)– IP address (when static connection mode isselected; default: 192.168.0.2)– Subnet mask (when static connection mode isselected; default: 255.255.255.0)– Default gateway (when static connection mode isselected; default: 0.0.0.0)Note• IP addresses can be entered using the keypad.[0]–[9] are used to enter numbers and [ ] isused to enter a period. For example, to enter"192.168.0.1", press [192 168 0 1].Automatic Assignment (DHCP)1. Press [MENU].2. Select "IP Network Settings", then pressSELECT.3. Select "IP Address Mode", then pressSELECT .4. Select "DHCP", then pressSAVE .5. Press [MENU].Note• If this setting is changed, the unit must berestarted before the new setting becomeseffective (see page 43).• To confirm the IP address, press[MENU]®"Show IP Address"®SELECT .Manual Assignment (Static)1. Press [MENU].2. Select "IP Network Settings", then pressSELECT.3. Select "IP Address Mode", then pressSELECT .4. Select "Static", then pressSAVE .5. Select "IP Address", then pressSELECT .6. Enter the IP address to be assigned to the unit, thenpressSAVE .7. Select "Subnet Mask", then pressSELECT .8. Enter the subnet mask, then pressSAVE .9. Select "Default Gateway", then pressSELECT .10. Enter the IP address of the default gateway, thenpressSAVE .11. Press [MENU].Note• If this setting is changed, the unit must berestarted before the new setting becomeseffective (see page 43).• To confirm the IP address, press[MENU]®[Show IP Address]®SELECT .24 Operating Instructions Document Version 2008/10Preparation