Panasonic KX-NT700 Quick Reference Manual

Also see for VoiceSonic KX-NT700: Specifications Operating instructions Quick reference guide Operating instructions Operating instructions

Contents

Panasonic KX-NT700 Quick Reference Manual Manual pdf 5 page image

USB PortUSB CableConnecting using the PC cableAB CDAUDIO IN/OUT JackPC CableMicrophone jack (red) of computerHeadphone jack (green) of computerConnecting an External Wired MICAn optional KX-NT701 External Wired MIC can beconnected to the unit using the EXT MIC1 (A) or EXTMIC2 (B) jacks. 2 mics can be connected.ABChanging the Language1. Press [MENU].2. Press [ ] or [ ] repeatedly to select "BasicSettings".3. Press [ENTER] two times.4. Press [ ] or [ ] repeatedly to select the desiredlanguage.5. Press [ENTER].6. Press [MENU].Operation ModeBy selecting an operation mode, the unit operates as aSIP extension of the PBX, peer to peer IP conferencingphone or USB audio device of a computer.1. Press [MENU].2. Select "Operation Mode", then pressSELECT .3. Select the desired setting. (default: "IP-PBX")• "IP-PBX": The unit can make and receive IPcalls as a SIP extension of the PBX.• "Peer to Peer": Peer to peer IP calls arepossible. To make a call, the other party’s IPaddress is specified.• "USB Audio": The unit operates as the USBaudio device of a computer.4. PressSAVE .5. For the new setting to take effect, disconnect the ACadaptor from the AC outlet, then connect it again torestart the unit.• When you are using PoE, disconnect the LANcable from the unit, then connect it again.Line SelectionWhether the TEL line, PS line, or PC line is available isdetermined by the "Line Selection" setting.1. Press [MENU].2. PressLINE .3. Select the desired setting.• "IP + TEL": The IP and TEL lines are available.• "IP + PS": The IP and PS lines are available.• "IP + PC": The IP and PC lines are available.4. PressSAVE .5. Press [MENU].Note• When the operation mode is set to "USBAudio", the "Line Selection" cannot beselected.• If you select "IP + TEL", change the dial mode(default: "Tone") if necessary:[MENU]®select "TEL Settings"®select"Dial Mode"®select "Pulse" or "Tone"®SAVE®[MENU]IP Network, SIP SettingsTo properly connect the unit to an IP network, thefollowing settings must be set to match the settings ofthe IP network.– IP address mode: Automatic (DHCP) or manual(static) IP address assignment (default: static)– IP address (when static connection mode isselected; default: 192.168.0.2)– Subnet mask (when static connection mode isselected; default: 255.255.255.0)– Default gateway (when static connection mode isselected; default: 0.0.0.0)To use the unit as a SIP extension of the PBX, the unitmust be registered as a SIP extension through PBXprogramming, the "Operation Mode" setting must beset to "IP-PBX" (this is the default setting), and thefollowing settings must be set to match the settings ofthe PBX.Document Version 2010/02 Quick Reference Guide 5Quick Reference Guide

/ 8

Related manuals for Panasonic VoiceSonic KX-NT700