FCC and other informationThis equipment is hearing aid compatible as defined by the FCC in 47 CFR Section68.316.When you hold the phone to your ear, noise might be heard in your Hearing Aid.Some Hearing Aids are not adequately shielded from external RF (radio frequency)energy. If noise occurs, use an optional headset accessory or the speakerphoneoption (if applicable) when using this phone. Consult with your audiologist orHearing Aid manufacturer about the availability of Hearing Aids which provideadequate shielding to RF energy commonly emitted by digital devices.WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TESTCALLS TO EMERGENCY NUMBERS:1) Remain on the line and briefly explain to the dispatcher the reason for the call.2) Perform such activities in the off-peak hours, such as early morning or lateevenings.This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:(1) This device may not cause harmful interference, and (2) this device mustaccept any interference received, including interference that may cause undesiredoperation.Privacy of communications may not be ensured when using this phone.CAUTION:Any changes or modifications not expressly approved by the party responsible forcompliance could void the user’s authority to operate this device.NOTE:This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.– Consult the dealer or an experienced radio/TV technician for help.For assistance, please visit http://www.panasonic.com/help 7Installation