2-2 Station Programming (Personal Programming)2.1 Station Programming InstructionsWhen storing dataAfter pressing the STORE button to store data, you may hear one of the following tones.— Confirmation tone (one beep): storage is completed.— Confirmation tone (two beeps): the data is the same as the last entry.— Alarm tone (three beeps): the entry is not valid.To exit the Station Programming modeStation Programming allows you, the proprietary telephone (PT) user, to program certainfeatures from your telephone individually. During the programming mode, yourtelephone is busy to outside callers. If you want to make a normal call operation, youmust finish the programming mode.Programming Mode DisplayWhen you enter the Station Programming mode, the display shows the followingmessage as the initial programming mode.The display also gives you helpful or stored data information related to the programmingsteps. In this section, the display example in the programming steps are noted, ifrequired. You can also refer to the “Display Examples” in the Appendix (Section 4).To enter the Station Programming modePITS-PGM NO? →PTPress PROGRAM.Be sure the telephone is idle and on-hook.PROGRAMPTWhen the display shows the initial programming modeProgramming is completedand the normal call operationresumes.Press PROGRAM.PROGRAM
