37KX-TCA256X(I)* Transmitted Power Con-firmationTP601 Remove the Antenna before starting step from 1 to 4.1. Configure the DECT tester (CMD60) as follows;• Test mode: PP• RFPI: 0102030408• Traffic Carrier: 5• Traffic Slot: 4• Mode: Loopback• RF LEVEL=-80dBm2. Execute the command "regcmd60 01 02 03 04 08".3. Initiate connection from DECT tester.4. Confirm that the NTP value at TP601 is 20dBm~25dBm.IC201,IC601,IC602,IC603,FIL601,C665,C661,L618, D601,C654,L616,R625,C657,L615,L614,C656,L610,C653,L611,C650,C646,R623,C642,C643,C645,R633,R634,R645,L619,C662,L617,L605,L603,R615,L612,L620(J)* Modulatoin Check andAdjusment- Follow steps 1 to 3 of (I) above.4.Confirm that the B-Field Modulation is 360kHz/div~380kHz/div using datatype Fig 31.5.Adjust the B-Field Modulation if required. (Execute the command "Readmod"and "wrtmod xx", where xx is the value.)IC201,IC601(K) Frequency Offset Confir-mation- Follow steps 1 to 3 of (I) above.4.Confirm that the frequency Offset is < ± 45kHz.IC201,IC601,IC602,IC603,FIL601,C665,C661,L618, D601,C654,L616,R625,C657,L615,L614,C656,L610,C653,L611,C650,C646,R623,C642,C643,C645,R633,R634,R645,L619,C662,L617,L605,L603,R615,L612,L620,C608,R603,C609,C607,R613,C606,L601,L602(L) Frequency Drift Confir-mation- Follow steps 1 to 3 of (I) above.4.Confirm that the frequency Drift is < ± 30kHz/ms.IC601,IC603,L619,L620,C662,L617,C660,R626,C634,L606,C633,C632,L608,C631,C630,C661,L618(M) Sensitivity ReceiverConfirmation- Follow steps 1 to 3 of (I) above.4.Set DECT tester power to -88dBm.5.Confirm that the BER is < 1000ppm.IC1,IC3,L2,C54,C60,C61,C62,C63,C64,C65,C66,C67,C69,C81,C82,C56,R58,R55,R76Items AdjustmentPointProcedure* Check orReplace Parts
