Panasonic KX-TCD700 Operating Instructions Manual

Contents

Current setting is displayedZ K - C to select volume0 = Ringer OFF1 = Low volume2 = Medium volume3 = High volume(Ringer sounds on selection)Z RCurrent setting is displayedZ A - B to selectDial Mode1 = Tone Dial Mode2 = Pulse Dial ModeZ R➡ Setup for Base StationTo Select the Base Unit Ringer Volume4 levels are available. The factory preset is MEDIUM. When set to OFF, the baseunit will not ring.To Select the Dialling ModeYou can program the dialling mode to tone or pulse. If you have touch toneservice, set the to tone. If rotary or pulse service is used, set to pulse. Thefactory preset is tone.Note: You can determine which type of local BT exchange you are connected tousing the following procedure:1. Ensure that the dialling mode is selected to tone.2. Z O, then identify the dial tone.3. Dial a number you are familiar with.4. If the call is successful, you are connected to a tone exchange. Thereforeleave the dialling mode as tone.5. If the call is not successful, you are connected to pulse exchange. Therefore,set the dialling mode to pulse.46(Standby Mode)-1-888888801Â Ê Á Ë È ÍÎ Ï  Ô Ó Òspeed dialÂ Ê Á Ë È ÍÎ Ï  Ô Ó Òsetting bsÂ Ê Á Ë È ÍÎ Ï  Ô Ó Òinput codeÂ Ê Á Ë È ÍÎ Ï  Ô Ó Ò• Select Ringer VolumeZ BZ BZ A221Â Ê Á Ë È ÍÎ Ï  Ô Ó Ò2222Â Ê Á Ë È ÍÎ Ï  Ô Ó Ò• Select Dial Mode(Tone/Pulse)Z CEnter 4 digit PIN No.3œœœœÂ Ê Á Ë È ÍÎ Ï  Ô Ó Ò3221Â Ê Á Ë È ÍÎ Ï  Ô Ó ÒA Confirmation tonesounds and displayreturns to function menu3121Â Ê Á Ë È ÍÎ Ï  Ô Ó Òsetting bsÂ Ê Á Ë È ÍÎ Ï  Ô Ó ÒA Confirmation tonesounds and displayreturns to function menusetting bsÂ Ê Á Ë È ÍÎ Ï  Ô Ó Ò28426_English 19/10/00 12:19 pm Page 46