24Feature TitleSection of O/I ItemPlease replace as follows in the conditions;•....Enter “ ” for a “–” (hyphen).• Enter “ ” for a PAUSE.• If there is a PAUSE in the assigned numbers, thenumbers after the PAUSE are sent as DTMF sig-nals.Please change as follows.• When you store the phone number, you don’t haveto dial ISDN port access code(9, 81or 82).• The ISDN port access numbers are ‘9’,’81’ and 82’.For the operation, Transferring a Call to CO Line(Call Transfer — to CO Line), you must perform thefollowing operations, Wait for an answer andAnnounce, even though the manual states “Omit ifnot necessary.” Please execute in proper order.If this operation is performed, the current call will beheld instead of being terminated.Please add the following condition;• If you receive an incoming call, ringing starts after the alarmstops sounding.• If you receive an incoming outside call in the 1:N status dur-ing the alarm, ringing starts after the alarm stops sounding.Please change the PROGRAMMING INPUT for bothSLT and PT.Sets the new rate (0. XX Pound)Sets the new rate (XXXXXXXX Pound)Quick DiallingDialling with a StationSpeed Dialling Button(Station SpeedDialling)Dialling Simply byGoing Off-Hook(Pickup Dialling)Dialling the StoredNumber with a SAVEButton (NotebookFunction)Quick DiallingDialling with a SAVEButton in Memo(Notebook Function)Transferring CallsCall WaitingAlarm Setting (TimedReminder)Charge Fee Reference2.3 Making Calls(P2-17)2.3 Making Calls(P2-18)2.3 Making Calls(P2-19)2.3Making Calls(P2-19)2.5During aConversation(P2-34)2.5During aConversation(P2-35)2.6 Others(P2-48)2.6 Others (P2-55, 56)Other changed itemsPTTalk to thenew caller.INTERCOMORPress flashing CO or INTERCOM.COWhile hearing a Call Waiting tone;(2 digits)new rate (XX)(The decimal point is a floating digit.)new rate (XXXXXXXX)(1···2, )ISDN port no.