2.3 System Data Control256 Feature Guide2.3 System Data Control2.3.1 PC ProgrammingDescriptionThis PBX can be programmed and administered using a personal computer (PC). There aretwo programming methods:1) On-site Programming: System programming/diagnosis can be performed locally byconnecting a PC to the PBX directly.2) Remote Programming: System programming/diagnosis and data upload can beperformed from a remote location.1. On-site Programming:Method DescriptionUsing the SerialInterface (RS-232C)portThe PBX has a Serial Interface (RS-232C) port which can beused for either system administration or SMDR.Using the USB port The PC is connected to the PBX or a DPT using a USB port.Using the LANinterfaceA CTI-LINK Card must be installed.Using a modemthrough an SLT portAny trunk card and a RMT Card must be installed. Assign thefloating extension number of the analogue remotemaintenance ( Modem Floating Extension Number), anddial this number from the PC to connect to the PBX.Using an ISDN TAinterface (64 kbps)through an ISDNExtension LineA BRI or PRI Card must be installed. Assign the floatingextension number of the ISDN remote maintenance ( ISDNRemote Floating Extension Number), and dial this numberfrom the PC to connect to the PBX. The RMT Card is notrequired for this method.
