2.1.3 Activation Key FileThe corresponding number of IP CO lines and IP telephones or enhanced features can be activated by installingthe downloaded activation key file(s) in the SD Memory Card of the IPCMPR card using the MaintenanceConsole.Installing the Activation Key File in the SD Memory CardMake sure to install the Maintenance Console on the PC in advance, and connect the PC to the PBX. Fordetails about the Maintenance Console, refer to "Section 4 Guide for the Maintenance Console".1. Start the Maintenance Console from the Start menu on the PC.2. From the Utility menu, select File Transfer PC to PBX (SD Card).A dialog box will be displayed.3. Select the file to upload.A window showing the upload progress will be displayed.While transferring files to the SD memory card, the PBX automatically renames them according to theheader information.A message will be displayed when the transfer is complete.4. Click OK.5. Under Configuration, click Slot.6. Click Activation Key.7. For IP trunk activation key file(s), click Execute.A confirmation message will be displayed. Click Yes.NoticeThe activation key file can only be installed in the PBX with the MPR ID number entered when the activationkey file was downloaded. The activation key file cannot be reissued unless the IPCMPR card crashes.Note• When the virtual cards are changed back to INS, the PC temporarily loses connection to the network.• It is necessary to restart the PBX to activate the Software Upgrade 01 activation key after performingthe procedure above. To restart the PBX, refer to "5.1.4 Using the Reset Button".• For information about programming activation keys using the Maintenance Console, refer to "SIPExtension" in the PC Programming Manual.Document Version 2011-10 Installation Manual 452.1.3 Activation Key File
