Panasonic KX-TG1000N Operating Instructions Manual

Also see for KX-TG1000N - 2.4GHz Cordless Phone: Installation manual

Contents

70Before Requesting HelpProblem“SEARCHING FOR BASE” isdisplayed and an alarm tonesounds.The unit does not work.When you try to make a call,the other voice is heard.You cannot dial.Static, sound cuts in/out,fades. Interference fromother electrical units.The handset does not ring.Remedy•You are too far from the base unit. Movecloser and try again.•Place the handset on the base unit andunplug the AC adaptor to reset. Plug in,and try again.•Re-install the handset battery and placethe handset on the base unit (p. 11, 65).Try again.•Check the settings (p. 10–13).•Charge the handset battery fully (p. 11).•Clean the charge contacts and chargeagain (p. 12).•Install the handset battery properly(p. 11, 65).•Place the handset on the base unit andunplug the AC adaptor to reset. Plug in,and try again.•Re-install the handset battery and placethe handset on the base unit (p. 11, 65).Try again.•The handset has not been registered.Register the handset (p. 54).•The handset or base unit is engaged inan external call. If you are using thehandset, wait until “LINE IN USE”disappears. If you are using the baseunit, wait until the IN USE indicator lightgoes out.•Check whether the dialing modeselection is correct (p. 13).•Locate the handset and the base unitaway from other electrical appliances(p. 3).•Move closer to the base unit.•The ringer volume is set to OFF.Select the desired volume level (p. 16).