Useful Information22TG1311_1312_1313E(e).book Page 22 Wednesday, June 4, 2008 4:10 PMInstructions to customerInstallationAttached to this telephone is an approval label. This label is evidence that it is a“Permitted Attachment” which has been authorised to be connected to yourtelephone service.Conditions relating to connection and operation of this Permitted Attachment arecontained in Telecommunications General By-Law 220 (5).You are authorised to install this Permitted Attachment yourself by plugging it into theline socket of any regular telephone. You may connect it in place of your existingtelephone or to any spare telephone socket installed in your premises.To disconnect your existing telephone you must first remove its plug from the linesocket. You can then insert the plug of your Permitted Attachment into the socket anduse your equipment.If the plug of your existing telephone cannot be readily removed, you will have toremove the screw securing it. To do this proceed as follows:1 Loosen screw “A” sufficiently to remove the socket cover. (See Fig. 1.)2 Remove screw “B” and withdraw the plug. (See Fig. 2.)3 Replace screw “B”. (See Fig. 3.) Ensure that it screws completely into the socketrecess. (If the screw is too long, increase the hole depth or replace the screw withone 5 mm shorter.)4 Replace socket cover and tighten screw “A”. (See Fig. 4.)SOCKETSCREW “A”PLUGFig. 1 TELEPHONE CORDConnect to the PLUGas shown in Fig. 1.( )SCREW“B”Fig. 2SCREW“B”Fig. 3SOCKETSCREW “A”Fig. 4If you are satisfied with the operation of your telephone service after plugging in yourPermitted Attachment, your installation is completed.You will be unable to connect this Permitted Attachment if your telephone serviceconsists only of a wall phone or an old style telephone which is not connected bymeans of a modern plug and socket. In such cases a new socket will need to beinstalled.Should the Permitted Attachment not operate when plugged into a socket, it is eitherfaulty or unsuitable for operation with your telephone service. It should be returned tothe store where purchased or to an Authorised Service Centre.