Using the Caller ListBasic Operation25For assistance, please call: 1-800-211-PANA(7262)Caller ID Number Auto Edit FeatureThere are 3 patterns of phone number ( , and , p. 24). This feature allowsyour phone to automatically edit an in-coming Caller ID number into a pattern ofyour choice, and display the Caller ID number with that pattern.After this feature is activated, Caller ID numbers coming from specific area codes(201, for example), from which the Caller ID numbers have been chosen to followthe desired pattern (7-digit pattern, for example), will be automatically edited fromother patterns (11-digit pattern, for example) into the same pattern you havepreviously selected (which is 7-digit pattern, in this example).Up to 4 area codes can be designated for this feature for pattern , and(p. 24).To activate this feature, you must (1) set this feature to ON, and (2) make an out-going call from Caller List (p. 23) with a number which has one of the 3 patterns thatyou have edited with specific area codes, and that you prefer to be followed byfuture Caller ID numbers, so that in the future all the Caller ID numbers coming fromthe same area code will be displayed in the same pattern.The Caller ID number Auto Edit feature is preset at the factory to ON.• If a call does not go through, the phone number you dialed may have an incorrectpattern. Please edit the phone number with another pattern (p. 24).For example, if you move to another area, you may need to turn this feature OFF toerase previously edited area codes. Then, if still necessary, you may activate thisfeature again.• When the feature is set to OFF, the unit will still be able to display Caller ID, but thein-coming Caller ID number will not be edited by a pattern or area codes.1 Press [MENU].2 Scroll to “Initial setting” by pressing [ ]or [ ], then press Select.3 Scroll to “Caller ID edit” by pressing [ ]or [ ], then press Select.4 Select “Off” or “On” by pressing [ ] or [ ].5 Press Save, then press [OFF].a b ca b c>> Initial settingExit Select>>>> Caller ID editBack Select>>>> Auto edit :OnBack Save>>