Voice Mail Service44Setting Voice Mail (VM) Tone DetectionYour telephone company sends special signals (Voice mail tones) to the unit.Press [C], [s] or [SP-PHONE] to listen to the dial tone. If you hear a series of dialtones followed by a continuous dial tone, this indicates that a new message wasrecorded. Voice Mail detection is preset at the factory to OFF. Minutes after youhang up or after the phone stops ringing, your unit will seize the phone line andcheck if a message has been recorded. If a new message was recorded at yourtelephone company, “Voice Mail” will be displayed on the handset, theRinger/Message Alert indicator on the handset will flash slowly if Message Alert isturned on (p. 20), and the VM indicator on the base unit will flash.Leave this programming off when:— you do not subscribe to a voice mail service,— your telephone company does not send a series of tones, followed by acontinuous tone to indicate that you have new voice mail, or— your phone is connected to a business or office telephone system (PBX).See below to turn this setting on.If you are not sure which setting is required, consult your local telephone companyor contact the Panasonic Customer Call Centre.1 Press [MENU].2 Scroll to “Initial setting” by pressing [d]or [B], then press Select.3 Press Select at “Voice Mail”.4 Scroll to “VM tone detect” by pressing [d]or [B], then press Select.5 Select “On” or “Off” by pressing [d] or [B].6 Press Save, then press [OFF].HandsetInitial settingBack SelectK dB LVoice MailBack SelectK dB LVM tone detectBack SelectK dB LVM tone detect:OffBack SaveK dB L