Panasonic KX-TG2511FX Operating Instructions Manual

Useful Information40Liquid damageCaution:L To avoid permanent damage, do not use a microwave oven to speed up the dryingprocess.Registering a handset to the base unit1 Handset:{j/OK}2 {V}/{^}: “Handset Setup” i {j/OK}3 {V}/{^}: “Register H.set” i {j/OK}4 Base unit:Press and hold {x} for about 5 seconds. (No registration tone)L If all registered handsets start ringing, press the same button to stop. Thenrepeat this step. (KX-TG2512/KX-TG2513)L The next step must be completed within 90 seconds.5 Handset:Wait until “Enter Base PIN” is displayed. i Enter the base unit PIN (default:“0000”). i {j/OK}L If you forget your PIN, contact an authorised service centre.L When the handset has been registered successfully, w stops flashing.Note:L If the registration fails, try to deregister the handset and then re-register it again.Press {j/OK} i {V}/{^}: “Base Unit Setup” i {j/OK} i {3}{3}{5}i {j/OK} i Select the handset(s) you want to cancel, by pressing thedesired handset number. i {j/OK} i {V}/{^}: “Yes” i {j/OK} iRepeat from step 1.Problem Cause/solutionLiquid or other form of moisturehas entered the handset/baseunit.L Disconnect the AC adaptor and telephone linecord from the base unit. Remove the batteriesfrom the handset and leave to dry for at least3 days. After the handset/base unit arecompletely dry, reconnect the AC adaptor andtelephone line cord. Insert the batteries andcharge fully before use. If the unit does notwork properly, contact an authorised servicecentre.TG2511_21FX(e).book Page 40 Tuesday, February 2, 2010 3:08 PM