Battery rechargeProblem Cause/solutionThe handset beeps and/orflashes.R Battery charge is low. Fully charge the batteries (page 11).I fully charged the batteries, but– still flashes,– is displayed, or– the operating time seems tobe shorter.R Clean the battery ends ( , ) and the charge contactswith a dry cloth and charge again.R It is time to replace the batteries (page 11).Making/answering calls, intercomProblem Cause/solutionis displayed. R The handset is too far from the base unit. Move closer.R The base unit’s AC adaptor is not properly connected.Reconnect AC adaptor to the base unit.R The handset is not registered to the base unit. Register it(page 31).Noise is heard, sound cuts inand out.R You are using the handset or base unit in an area withhigh electrical interference. Re-position the base unit anduse the handset away from sources of interference.R Move closer to the base unit.R If you use a DSL/ADSL service, we recommendconnecting a DSL/ADSL filter between the base unit andthe telephone line jack. Contact your DSL/ADSL providerfor details.The handset does not ring. R The ringer volume is turned off. Adjust the ringer volume(page 18).R Silent mode is turned on. Turn it off (page 29).The base unit does not ring. R The ringer volume is turned off. Adjust the ringer volume(page 18).I cannot make a call. R The dialing mode may be set incorrectly. Change thesetting (page 16).I cannot make long distancecalls.R Make sure that you have long distance service.For assistance, please visit http://www.panasonic.com/help 49Useful Information