64KX-TG4763B/KX-TGA470B/KX-TGA405B12.7. Things to Do after Replacing IC or X'talIf repairing or replacing EEPROM and X'tal, it is necessary to download the required data such as Programming data or adjustmentdata, etc in memory.The set doesn't operate if it is not executed.12.7.1. How to download the data12.7.1.1. Base UnitFirst, operate the PC setting according to The Setting Method of JIG (P.56).Then download the appropriate data according to the following procedures.Note:(*1) XXX_YYY: revision number“XXX”, “YYY” vary depending on the country version. You can find them in the batch file, PNZZ- mentioned in The SettingMethod of JIG (P.56).Items How to download/Required adjustmentEEPROM (IC611) Adjusted parameter data is stored in memory.(country version batch file, default batch file,etc.)1) Change the address “0001” of EEPROM to “55” to downloadthe data.2) Default batch file: Execute the command “default.bat”.3) Country version batch file: Execute the command“TG4741US_US_RevXXX_YYY.bat”. (*1)4) Clock adjustmentX'tal (X1) System clock Clock adjustment data is in EEPROM, adjust the data againafter replacing it.1) Apply 5.5V between DCP ad DCM with DC power.2) Input Command "sendchar sfr", then you can confirm thecurrent value.3) Check X'tal Frequency.(13.824 MHz ± 100 Hz).4) If the frequency is not 13.824 MHz ± 100 Hz, adjust thefrequency of CLK executing the command "sendchar sfr xx xx(where xx is the value)" so that the reading of the frequencycounter is 13.824000 MHz ± 15 Hz.
