Panasonic KX-TG5230AL Operating Instructions Manual

Contents

If the Following Appear on Your Display...66Error!!• When you tried to register or deregister the handset,the handset and base unit could not link for somereason, such as interference from electricalappliances. Move the handset and base unit awayfrom any electrical appliances and try again.• If more than one handset is in use, you may not beable to register/deregister. Try again later.• Another handset tried to send phone book items toyou but copying stopped. Have the other handsetuser re-send the items to you (p. 39, 40).System is busy.Please try againlater.• If more than one other user is using the handset and/or base unit, such as conducting outside/intercomcalls, you may not be able to use the handset. Tryagain later.• The handset has lost communication with the baseunit. Walk closer to the base unit and try again.Phone book full • When you tried to store an item in the phone book,the phone book memory was full. Press [OFF] to exitprogramming mode. To erase other items from thephone book, see page 38.---Incomplete---Tom Jones0987654321Phone book full(The name/number isan example.)• When the displayed item was sent to the destinationhandset, the phone book memory was full andcopying stopped. If you tried to send all of the items,the item displayed with “Incomplete” and itemsafter it have not been copied to the destinationhandset. Press [OFF] to exit (p. 39, 40). To eraseitems from the destination handset phone book, seepage 38. You can copy all of the items again or copythe items which have not been copied one by one(p. 39, 40).---Incomplete---Tom Jones0555654321(The name/number isan example.)• The destination handset is out of area.• The destination handset user may have pressed[C] or [s].Phone bookNo items stored• Your phone book is empty. No items were copied tothe destination unit.Denied • The Room Monitor feature is turned off on thedestination handset or base unit and cannot bemonitored (p. 49).• The called handset was on the base unit. Thehandset must be off the base unit to be monitored.Display message Cause & RemedyTG5230AL.fm Page 66 Friday, June 11, 2004 5:31 PM