Multi-unit Operation31Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333flashing. If keytones are turned on(page 19), a confirmation tone will beheard.Cancelling a handsetA maximum of 6 handsets can be registeredto the base unit. A handset can cancel itsown registration (or the registration ofanother handset) that is stored in the baseunit. This will allow the base unit to “forget”the handset.1 {j/OK} i “Base Unit Setup” i{>}2 Enter “335”.3 “Cancel Handset” i {>}L The numbers of all handsetsregistered to the base unit aredisplayed.4 Select the handset(s) you want tocancel, by pressing the desired handsetnumber.L The selected handset number(s) willflash.L To cancel a selected handset number,press the number again. The numberwill stop flashing.5 {j/OK} i “Yes” i {>}L A long beep will sound as eachhandset number disappears.L The handset does not beep whencancelling its own registration.6 {ih}Increasing the range of the baseunitYou can increase the signal range of thebase unit by using a DECT repeater. Pleaseuse only the Panasonic DECT repeaternoted on page 5. Consult your Panasonicdealer for details.Important:L Before registering the repeater to thisbase unit, you must turn the repeatermode on.L Do not use more than one repeater at atime.Setting the repeater mode1 {j/OK} i “Base Unit Setup” i{>}2 “Other Options” i {>}3 “Repeater Mode” i {>}4 “On” or “Off” i {>} i {ih}Note:L After turning repeater mode on or off, wwill flash on the handset momentarily. Thisis normal. The handset can be used oncew stops flashing.Intercom betweenhandsetsIntercom calls can be made betweenhandsets.Example: When handset 1 calls handset 21 Handset 1:{INT} i Press {2} (desired handsetnumber).2 Handset 2:Press {C} / {s} to answer.3 When finished talking, press {ih}.Transferring callsbetween handsetsOutside calls can be transferred between 2people.TG7160-7180E(e).book Page 31 Thursday, July 27, 2006 12:45 PM