Programming27Changing the start and end time1 1 i {#}{2}{3}{7}2 Continue from step 3, “Turning nightmode on/off”, page 26.Setting the ring delayThis setting allows the handset to ringduring night mode if the caller waits longenough. After the selected amount oftime passes, the handset rings. If youselect “No Ringing”, the handsetnever rings during night mode.1 1 i {#}{2}{3}{9}2 {V}/{^}: Select the desired setting.i M i {ic}Selecting categories to bypass nightmode1 1 i {#}{2}{4}{1}2 {V}/{^}: Select your desiredcategories. i tL “Q” is displayed next to theselected category numbers.L To cancel a selected category,press t again. “Q” disappears.3 M i {ic}Note:L You can also select the categories instep 2 as follows:Press {1} to {9}. i MChanging the handset nameEach handset can be given acustomised name (“Bob”, “Kitchen”,etc.). This is useful when you makeintercom calls between handsets. Youcan also select whether or not thehandset name is displayed in standbymode. The default setting is “Off”. Ifyou select “On” without entering anyhandset name, “Handset 1” to“Handset 6” is displayed.1 1 i {#}{1}{0}{4}2 Enter the desired name (max. 10characters; page 35).L If not required, go to step 3.3 M4 {V}/{^}: Select the desired setting.i M 2 times5 {ic}Storing an area code to bedeleted automaticallyIn some situations, phone numbersstored automatically in the caller list(page 32) will include area codes. If youdo not want to dial the area code whenmaking calls from the caller list, you canstore the area code which you want theunit to delete automatically.Example: You have stored the areacode “123”. If you make a call from thecaller list to the phone number “123-456-7890”, the unit dials “456-7890”.1 1 i {#}{2}{5}{5}2 Enter an area code (5 digits max.).i M i {ic}Incoming call barring (CallerID subscribers only)This feature allows the unit to reject callsfrom specified phone numbers that youdo not want to answer such as junk calls.When a call is received, the unit does notring while the caller is being identified. Ifthe phone number matches an entry inthe call barred list, the unit sends out abusy tone to the caller, and thendisconnects the call.Important:L When the unit receives a call from anumber that is stored in the call barredlist, the call is logged in the caller list(page 32) with 7 after the call isdisconnected.TG7511CX(e).book Page 27 Wednesday, March 24, 2010 8:41 AM