Programming12Registering a unitOperating additional unitsAdditional handsetsUp to 6 handsets can be registered to asingle base unit.Fontos:L The additional handset modelrecommended for use with this unit isnoted on 5. oldal. If another handset modelis used, certain operations (handsetsettings, base unit settings, etc.) may notbe available.Additional base unitsHandsets can be registered to up to 4 baseunits, allowing you to add additional baseunits and extend the area in which yourhandset(s) can be used. If a handset movesout of range of its base unit when“Automata” is selected on base unit (31.oldal), it looks for another base unit to makeor receive calls. A base unit and the handsetsit communicates with is called a “radio cell”.Megjegyzés:L Calls are disconnected when the handsetmoves from one radio cell to another.Registering a handset to a baseunitThe supplied handset and base unit are pre-registered. If for some reason the handset isnot registered to the base unit (for example,w flashes even when the handset is near thebase unit), register the handset.1 Handset:K (centre of joystick) i N i M2 {V}/{^}: “Regisztráció” i M 2times3 {V}/{^}: Select a base unit number. iML This number is used by the handsetas a reference only.4 Base unit:Proceed with the operation for yourmodel.■ KX-TG8411Press and hold {x} for about 5seconds. (No registration tone)■ KX-TG8421Press and hold {x} for about 5seconds, until the registration tonesounds.L If all registered handsets start ringing,press the same button to stop. Thenrepeat this step.L The next step should be completedwithin 90 seconds.5 Handset:Wait until “Bázis PIN beír.” isdisplayed. i Enter the base unit PIN(default: “0000”). i ML If you forget your PIN, contact yournearest Panasonic service centre.L When the handset has beenregistered successfully, w stopsflashing.Megjegyzés:L When you purchase an additionalhandset, refer to the additional handset’sinstallation manual for registration.TG8301-8321HG(e-hg).book Page 30 Tuesday, April 29, 2008 9:47 AM