– 4 –Answering system6 Frequently asked questionsFeature OperationAnswering on/off J (centre of joystick) i I i L i e i{ih}Listening to messages J (centre of joystick) i I i L i “Play NewMsg.” or “Play All Msg.” i LQuestion Cause & solutionWhat kind of power outletshould I connect the ACadaptor to?L Connect the AC adaptor to a 220–240 V outlet.Why is w flashing? L The handset is too far from the base unit. Move closer.L The AC adaptor is not connected. Check theconnections.L You are using the handset or base unit in an area withhigh electrical interference. Place the handset and baseunit away from interference sources, such as antennasand mobile phones.L The handset is not registered to the base unit. Register it.J (centre of joystick) i m i L i“Registration” i L i “Register H.set” iL i Select a base unit number. i L i Pressand hold {x} on the base unit for about 3 seconds, until theregistration tone sounds. i Wait until “Enter BasePIN” is displayed. i Enter the base unit PIN (default:“0000”). i LWhy is the handset displayblank?L The handset is in screen saver mode. Press {ih} toactivate the handset display again.L The handset is not turned on. To turn the power on, press{ih} until a short beep sounds.What should I do when thehandset does not turn on?L Make sure that the batteries are installed correctly.L Fully charge the batteries.L Clean the charge contacts and charge again.How long should I charge newbatteries?L Charge the batteries for about 7 hours.TG9120_40_50E(e)_QG.fm Page 4 Friday, July 21, 2006 10:45 AM