Battery installation/Battery chargingImportant:R Use the supplied rechargeable batteries. For replacement, we recommend usingthe Panasonic rechargeable batteries noted on page 2.R Wipe the battery ends ( , ) with a dry cloth.R Avoid touching the battery ends ( , ) or the unit contacts.R Confirm correct polarities ( , ).R USE ONLY Ni-MH batteries AAA (R03) size.R Do NOT use Alkaline/Manganese/Ni-Cd batteries.Charge for about 7 hours.R When the batteries are fully charged, the charge indicator goes off and “Fullycharged” is displayed.RechargeableNi-MH ONLY Confirm“Charging”is displayed.Note:R If the batteries are fully charged, but the operating time seems to be shorter,clean the battery ends ( , ) and the charge contacts with a dry cloth andcharge again.Registering a handset to a base unit1 Base unit:Press and hold MLOCATORN for about 5 seconds.R Depending on the base unit, a registration tone sounds.R If all registered handsets start ringing, press MLOCATORN again to stop,then repeat this step.2 Handset:Place the handset on the base unit or charger, then wait until a long beepsounds and stops flashing.Note:R If an error tone sounds, or if is still flashing, register the handset according tothe base unit’s operating instructions.For assistance, please visit http://www.panasonic.com/help 3InstallationTGA421(en)_1129_ver021.pdf 3 2012/11/29 14:56:20