Panasonic KX-TGA520C Installation Manual

Contents

Panasonic KX-TGA520C Installation Manual Manual pdf 3 page image

– 3 –RegistrationThis cordless handset must be registered to a KX-TG5200C/KX-TG5202C/KX-TG5230C/KX-TG5240C/KX-FPG391C base unit. The handset will be assigned the extension numberat registration. Only one handset can be registered at a time. Charge the battery fully.Make sure the base unit and the other handsets are not being used. Have both thehandset and base unit nearby during registration.• Base unit model shown here is KX-TG5240C.* The location of the LOCATOR button varies by base unit model.KX-TG5200C/KX-TG5202C: LOCATOR [ ], [ ], [ ], [ ] or [ ]KX-TG5230C/KX-TG5240C/KX-FPG391C: [LOCATOR/INTERCOM/TRANSFER]The handset display shows the instructions as shown on theright.• The registered number “[1]” to “[4]” is shown on the top right of the display.• You can stop registration by pressing [OFF] on the handset and pressing the *LOCATORbutton on the base unit.• If you try to register this handset to the KX-TG6500C base unit, “Wrong handsetRefer to manual” is displayed. The base units for this handset are mentioned above.1 Base unit: Press and hold the *LOCATOR button for 3 seconds.• The CHARGE indicator flashes. After the CHARGE indicator starts flashing, the rest ofthe procedure must be completed within 1 minute.• On the KX-FPG391C, “HS REGISTRATION” is displayed.2 Handset:(1) Press the soft key ( ).(2) Wait until a long beep sounds and the displayshows the new extension number.• Registration is complete.To cancel the handset registration, please see your base unit Operating Instructions.OKOKBACKBACKCHARGE Indicator*LOCATOR ButtonTo operate “ ”,press the right soft key.OK1Press LOCATORon base unitfor 3 sec.Then press OK[-]LPress LOCATORon base unitfor 3 sec.Then press OKLBACK FRANÇ. O KOKSPIPRIVACY1HandsetRegisteringIN USE [- ]SPIPRIVACY1Handset [2]RegisteredIN USE [2 ]e.g. Extension number 2