Camera Monitoring14Camera monitoringusing a handsetWith a colour display handset (KX-TGA591AL), you can monitor the imageand sound of the room where the cordlesscamera is located. The monitored cameradoes not ring, allowing you to easilymonitor a baby’s room, for example, fromdifferent areas of the house.Important:L Before you start monitoring, confirm thatthe camera lens of the cordless camerahas been adjusted to the correct angle.L Only 1 person can access the cordlesscamera at a time.L A refreshed image taken by the cordlesscamera is displayed every few seconds.The displayed image is not a movingpicture. Selecting enhanced motionmode shortens the interval (page 11).L While monitoring a cordless camera,other users cannot make an intercomcall or transfer a call.L The monitoring connection isautomatically cancelled after 10minutes.L While monitoring you cannot place thehandset on the base unit or charger. Themonitoring connection will be cancelled.L The cordless camera may not pagehandsets in the following conditions:– when other users are on an intercomor conference call.– when electrical interference is emittedfrom electrical devices.– while you are on a call with thehandset. (In this case you will hear 2tones and z will flash on thehandset.)Monitoring the cordless camerafrom a handset1 {INTERCOM}2 Select the desired cordless camera.i {CALL}3 Speak to the cordless camera user ifnecessary.ORTo mute your sound output, press{MUTE} if necessary.4 When you finish monitoring, press{OFF} or place the handset on the baseunit or charger.Adjusting receiver/speaker volumePush {^} or {V} while monitoring.Talking to the paged party using thecordless cameraWhen the cordless camera is paged from ahandset, the cordless camera does notring and the speakerphone is turned on.Handset