Key Operation2 Skip message (during playback)4 Play new messages5 Play all messages9 Stop playback0 Turn answering system off*4 Erase currently playing message*5 Erase all messages*# End remote operation(or hang up)*1 If pressed within the first 5 seconds of amessage, the previous message isplayed.Turning on the answering systemremotely1 Dial your phone number from atouch-tone phone.2 Let the phone ring 15 times.R A long beep is heard.3 Enter your remote access code within 10seconds after the long beep.R The greeting message is played back.R You can either hang up, or enter yourremote access code again and beginremote operation (page 32).Answering system settingsCall screeningWhile a caller is leaving a message, you canlisten to the call through the handset’s speaker.To adjust the speaker volume, press MDN orMCN repeatedly.You can answer the call by pressing M N.Call screening can be set for each handset.The default setting is “On”.1 MMENUN#3102 MbN: Select the desired setting. aMSAVEN3 MOFFNNumber of rings before the unitanswers a callYou can change the number of times thephone rings “Ring count” before the unitanswers calls. You can select 2 to 7 rings, or“Toll saver”.The default setting is “4 rings”.“Toll saver”: The unit’s answering systemanswers at the end of the 2nd ring when newmessages have been recorded, or at the endof the 5th ring when there are no newmessages. If you call your phone from outsideto listen to new messages (page 32), youknow that there are no new messages whenthe phone rings for the 3rd time. You can thenhang up without being charged for the call.1 MMENUN#2112 MbN: Select the desired setting. aMSAVEN a MOFFNFor Voice Mail service subscribersIf you subscribe to a flat-rate service packagethat includes Call Display, Call Waiting, VoiceMail, and unlimited local/regional/longdistance calls, please note the following:R To use the Voice Mail service provided byyour service provider/telephone companyrather than the unit’s answering system,turn off the answering system (page 30).R To use this unit’s answering system ratherthan the Voice Mail service provided byyour service provider/telephone company,please contact your service provider/telephone company to deactivate yourVoice Mail service.If your service provider/telephone companycannot do this:– Set this unit’s “Ring count” setting sothat this unit’s answering systemanswers calls before the Voice Mailservice of your service provider/telephone company does. It is necessaryto check the number of rings required toactivate the Voice Mail service providedby your service provider/telephonecompany before changing this setting.For assistance, visit www.panasonic.ca/english/support 33Answering SystemTGC2xxC_(en_en)_0413_ver120.pdf 33 2015/04/13 11:54:43